please explain what you've done and what you've measured so we can understand a little better
Excellent suggestion jerry!

As you probably know, it was your thread about adding sugar to the lynette baxter spice mix that started me thing about this and prompted my question. I assumed that the spices needed to be fried at far higher than 100C (to release their flavours and fully cook them) and that the sugar in your spice mix would therefore melt and burn. So rather than just speculate, I thought Id go and measure what actually happens in practice.
I have no doubt that most of us struggle to get anywhere near the taste and smell of a DECENT bir curry, when making them at home, although we many of us often kid ourselves that we can.
There are clearly differences between what birs do and what we do (or can do) at home which account for these differences. Otherwise there wouldnt be a difference. And I dont believe that it is entirely down to "experience".
So, I thought i would measure my pan to see how hot it actually got at the front end of making a curry (given yours and santas comments in the other thread).
So i used a 32cm cast iron wok. I heated it on my largest gas ring 12MJ/h (3.3kW)
I used an infrared thermometer to measure how hot the pan was as it started to smoke. It was over 220C (this is the upper limit of my thermometer).
I then added about 4 tablespoons of canola oil and heated it until just started to smoke. It was over 220C.
I then added 1 chopped onion and fried it for 5 to 10 minutes. The temperature of the onion was between 90C and 110C until it began to brown after 5 minutes or so (gas was always on full). Only once the onion began to brown (a visual sign that the temperature was rising, probably because most of the water had evaporated) the temperature rose to 130C to 150C.
I then added a reasonably runny spice paste (water plus ground spices) and the temperature of the ingredients immediately dropped to 80C to 90C and remained there for several minutes (even when the spice paste was "churping" and "cratering" jerry).
I then added uncooked chicken cubes. The temperature of the ingredients dropped to 60C to 90C and never got any hotter.
Hmmmm, now people can pick fault in my rough and ready check and avoid the real question that should be asked (im not asking it again)

i know what your getting at and i'm 100% attentive - do we all need to buy a propane burner or can we get the BIR taste on our measly standard electric hob (mines is a 1.5kw) or gas hob
I think thats premature jerry, until we have answered the original question. Are these temperatures hot enough to fully release the flavours of the spices (damn it! I asked the question again!). Arguable they are?
I think the real problem with weedy domestic cookers is their inability to MAINTAIN a decent high temperature when ingredients are added (clearly, this is the case from my results)i think the answer is yes but Domi has now got me uncertain
You probably shouldnt be unduly side-tracked by those who are "satisfied" with their results jerry (not if youre after replicating a decent bir curry that is)
please use your prob to measure the temp of the hob itself on full wack. i presume you are aiming it inside the pan
Greater than 220C is all i can say (the upper limit if my thermometer)
in short i am now gutted - maybe its the oil that's effectively burnt in the BIR that gives the smokey taste (ie before anything is added)
I doubt that they burn the oil jerry
